Double angle, plated finish
Double angle 1.5mm thickness (16 gauge) steel angle. Standard punching (3 holes per 'U') in narrow flange for rack mounting, mounting slots punched in 53mm side flange, standard punching in 'sideways' rear flange for mounting horizontal rails, slides, cable tray etc. Supplied in 1820mm (41U) and 2000mm (45U) lengths. Zinc plated finish, clear passivated. Cage nuts type 16-025 are suitable for use with this strip.
Double angle, black painted finish
Double angle 1.5mm thickness (16 gauge) steel angle. Standard punching (3 holes per 'U') in narrow flange for rack mounting, mounting holes punched in wide flange, 2 hole punching per 'U' in 'sideways' rear flange for mounting horizontal rails, slides, cable tray etc. Supplied in 2 metre lengths (45U). Black painted finish. Cage nuts type 16-025 are suitable for use with this strip.
Double angle, reduced depth, plated finish
Double angle 1.5mm thickness (16 gauge) steel angle, with reduced depth side section. Standard punching (3 holes per 'U') in narrow flange for rack mounting, mounting slots 10.3 x 6.8mm punched in 28mm side section, standard punching in 'sideways' rear flange for mounting horizontal rails, slides, cable tray etc. Supplied in 2000mm lengths (45U). Zinc plated finish, clear passivated. Cage nuts type 16-025 are suitable for use with this strip.
Single angle, plated finish
'L' section 2.0mm thickness (14 gauge), heavy duty steel angle 50mm x 18mm. Standard punching (3 holes per 'U') in narrow flange for rack mounting, mounting slots punched in wide flange. Supplied in 1820mm (41U), 2000mm (45U) lengths. Cage nuts type 16-026 are suitable for use with this strip.
Also available in a selection of pre-cut shorter lengths (1U - 12U) of 1.5mm thickness (16 gauge) steel. Ideal for DIY racks or for flight cases, console inset mounting etc. Cage nuts type 16-025 are suitable for use with this strip.
Zinc plated finish, clear passivated.
Single angle, black painted finish
'L' section 1.5mm thickness (16 gauge) steel angle 32.5mm x 19mm. Standard punching (3 holes per 'U') in narrow flange for rack mounting, mounting holes punched in wide flange. Supplied in 2 metre lengths (45U). Black painted finish. Cage nuts type 16-025 are suitable for use with this strip.
Construction note: Spacing between outer (mounting) verticals should be 486mm. This then gives correct alignment of holes and DIN standard aperture width of 450mm.
Ordering note: All items are priced and sold singly.